logo

Lithiumate™ Manual

index install install_controller_hvfe

Install - BMS controller with HVFE

Installation instructions for the 2CN0xxxH encased BMS controller with HV Front End.

back to topGood technique

Unfortunately, we do not have the resources to teach all of our clients proper assembly procedures, which are essential for a succesful project. What we can do is pass along this info to you:

Please see the Controller installation and the HVFE installation pages: HVFE installation (or, for older systems, local HVFE installation).

Note that, to connect to a high current sensor, you will need to open the case (4 screws).

e-logo

© 2008~2024 Elithion™, LLC. All rights reserved, except where noted by CC mark. Page published on Jul 19 2013.
The Elithion brand and the 'ə' (upside down 'e') logo are Trademarks of Elithion LLC. Graphic design by morninglori

 

In this page: