Using a Curtis invereter with a Lithiumate Lite BMS.
The Lithiumate Lite may control a Curtis 123x motor inverter either though wire control or through CAN messages.
WARNING: SHOCK DANGER
The Curtis motor controllers do not provide isolation between the high voltage battery and the low voltage circuits.
This poses a significant risk of shock and of likely damage to the low power electronics by way of a single unintentional short circuit.
This proposed ciruit adds isolation to the Curtis motor controller to improve safety.
The system has a traction pack and an auxiliary 12 V battery.
The ignition switch is on the 12 V battery, not the traction pack.
When the ignition is on, and if discharging is OK, the Lithiumate Lite master turns on K1, which powers the Curtis inverter, from the traction pack to the KSI input.
The Lithiumate Lite master limits the discharge current through its Throttle Reduce analog output, by shunting the output of the throttle.
It disables regen current through a relay driven by the Charge OK output, by disabling the brake.
Isolation is achieved by:
By reading this page you acknowledge that you understand that this application note is just a suggestion, and that you will not hold Elithion responsible for its accuracy or appropriateness in you application, and that Elithion is not responsible for the fact that other manufacturers change their products in a way that may make these suggestions no longer applicable.