home support product_info vinci_bms vinci_bms_components vinci_bms_hv_modules

Vinci HV BMS modules

For high voltage stationary batteries, such as grid tied

A Battery Master and an Application Module are required for each battery.

Vinci module
VinciBus Master

VinciBus Master

A VinciBus Battery Master communicates with VinciBus Slaves through a 5-wire VinciBus.

May include an optional communication board, for one of the following communications links.

Part number Link Protocol
3MH0000B None
3MH0001B CAN XanBus™
3MH0002B RS485 RTU ModBus
3MH0003B Ethernet TCP/IP ModBus
3MH0004B RS232 Generic
VinciBus Master
VinciBus Master

Specifications

General specifications

Detailed specifications are in the Vinci BMS Manual.

VinciNet Master

A Battery Master required for each battery.

A VinciNet Battery Master communicates wirelessly with VinciNet Slaves, achieving complete isolation.

May include an optional communication board, for one of the following communications links.

Part number Link Protocol
3MH0000N None
3MH0001N CAN XanBus™
3MH0002N RS485 RTU ModBus
3MH0003N Ethernet TCP/IP ModBus
3MH0004N RS232 Generic
VinciNet Master
VinciNet Master

Specifications

General specifications

Detailed specifications are in the Vinci BMS Manual.

Application Module

An Application module monitors battery voltage and current, drives contactors and tests isolation.

Multiple models are offered, for different voltage ranges.

Part number Voltage
3MH0008A 0.8 kV
3MH0012A 1.2 kV
3MH0016A 1.6 kV
Vinci module
Application module

Specifications

General specifications

Detailed specifications are in the Vinci BMS Manual.

Protector Switches

Each battery requires a protector switch to turn off the battery current and a current sensor.

Elithion offers these external protector switch sets consisting of:

Positive set:
  • Positive contactor
  • Precharge relay
  • Precharge resistor
  • Voltage sense divider
  • Hall effect current sensor
Mid set:
  • Mid-pack safety contactor
  • Safety push-button switch
  • Fuse
  • Fuseholder
Negative set:
  • Negative contactor
  • Post-discharge relay
  • Post-discharge resistor
  • Voltage sense divider
Part number Current Voltage
3SH1508C 150 A 0.8 kV
3SH3008C 300 A 0.8 kV
3SH3015C 300 A 1.5 kV
3SH6008C 600 A 0.8 kV
3SH9908C 1000 A 0.8 kV
Protector switch
Protector switch

Specifications

General specifications

Detailed specifications are in the Vinci BMS Manual.

Ordering

 

In this page:
VinciBus Master
VinciNet Master
Application Module
Protector Switches
Ordering
 
© 2008~2024 Elithion™, Inc.. All rights reserved. The Elithion brand and the logo with an 'ə' (upside down 'e') are Trademarks of Elithion Inc.
Policies - Contact us - Mobile site Page published on Feb 06 2018.
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
Pop-up enlargement