StandardProducts/Lithiumate/Service/Troubleshooting/Banks/Missing/Battery

<h1>No banks are reporting</h1>

All banks may be missing because: 
<ul>
	<li>The BMS controller is misprogrammed, 
	<li>There truly are problems with each and every bank 
</ul>

First: 
<ul>
	<li>Make sure that all banks missing, and not just some banks; if the latter, see the <a href="../Bank">Missing bank</a> section 
	<li>Make sure that all banks missing, and not just some cells; if the latter, see the <a href="../Cell">Missing cell</a> section 
	<li>Make sure that the problem is not due to electrical noise; if so, see the <a href="../Noise">Noise</a> section 
</ul>

Procedures:


<ul>
	<li>Check that the BMS controller does expect to see banks 
	<ul>
		<li>On the terminal, do Home / Set-up / More... / Battery arrangement / Number of cells in each bank / Set manually 
		<li>If the number of cells in bank 0 is 0, that's the problem, or at least part of the problem 
		<ul>
			<li>Press ESC, then Learn Automatically / Enter 
			<li>If the problem persists, then the problem is that all banks have problems communicating: proceed as below 
			<ul>
				<li>With the BMS power on, see if any cell boards are blinking 
				<li>For each bank, proceed with the test depending on which cells blink: 
				<ul>
					<li><a href="../Bank/None">None blink</a>: No cell board is blinking 
					<li><a href="../Bank/All">All blink</a>: All cell boards blink 
					<li><a href="../Bank/Part">Part</a>: From the positive end board up to a certain point they blink, then the rest don't blink 
					<li><a href="../Bank/Random">Random</a>: Some blink, some don't, with no apparent pattern  
				</ul>
			</ul>
		</ul>
	</ul>
</ul>